Repair Manual

Manual Guide Mounting Kit Installation 1994 Ford Crown Victoria SA340TS

This 1994 Ford Crown Victoria SA340TS mounting installation kit ebook guide provides all the information necessary for your Whelen product to be installed correctly and safely. Before starting the installation and / or operation of its new product, the installation technician and operator must read this manual thoroughly.

• Proper installation of this product requires the installation to have a good understanding of automotive electronics, systems and procedures.

• If mounting this product requires drilling holes, the installer must ensure that no vehicle components or other vital parts could be damaged by the drilling process. Check both sides of the mounting surface before drilling begins. Also de-burr the holes and remove metal fragments or debris. Install rings on all wire passage holes.

Facility:
1. Connect the siren driver before installation.
2. Install the mounting bracket and horn driver pushing through air flow openings in the bottom of the vehicle, and by hanging the fixture at the bar near its center line.
3. Locate the mounting bracket stand behind Sill vehicle siren
4. 05/16 Pass? hex head screws on the front clamp assembly cradle.
5. Press the horn Twinsonic through air flow openings in the bottom of the vehicle. Place the speaker in the driver’s mouth and thread at the tip of the horn.
6. Place the whole in an upright position and tighten the two hex screws.

http://www.whelen.com/install/135/13530.pdf