Thursday, November 8, 2012
ACURA INTEGRA GSR VTEC THROTTLE BODY INSTALLATION INSTRUCTIONS
Note: Engine coolant may run from the hoses once removed.Rata PenuhDisconnect the throttle linkage by opening the throttle manually and slipping the cable from the cam groove on the linkage.Remove the four nuts securing the throttle body to the intake manifold and remove it.Remove the MAP (see Figure 1 for MAP sensor location) sensor from the factory throttle body. Use the new O-ring with the blue stripe from the kit contents to seal the MAP sensor to the throttle body. Attach the MAP sensor to the new throttle body using the factory screws.Remove the idle air control (IAC) motor (see Figure 1 for IAC motor location) from the factory throttle body.
Using the factory bolts and the O-rings supplied in the kit, attach the IAC to the new throttle body. The o-rings are color-coded so refer to Figure 1 for proper installation. Torque down bolts to 10 N·m or 7 lbf·/ft.
get download here