Wednesday, May 25, 2011
VW Mk5 Subframe Brace installation instructions
Installation instructions:
Step 1: Raise the back of the car and protect it from the stands of Jack. Never work in the car supported only by the hydraulic floor Jack. Check your owner manual for the correct affixing of the stands jacks floor and Jack.
Step 2: determine the area of the rear subframe. You will be working in the area located just below the rear anti-roll bar. Here is a shot intended to combat radioelektronicznej of the exhaust system removed for clarity. Exhaust system do not need to move for this installation.Step 3: Carefully manuever Stern subframe brace to the position. Is this patience little, as niewmontowanych is close. Be sure to orient brace with the logo of rufowa facing the front of the car and in a vertical position so that it can be read. In the picture below we have highlighted three areas in which the space for mounting. Again, the exhaust system was removed only explanation. The two ends of the open will be mounted right next to parentheses stabilizer bar, while the Rear mounting will attach just above and between the rear knuckle arm collection. All openings used are existing and already located on a subframe. There is no need for any openings. Cieplochronnej attached to the tank of gas, need to be bent slightly back to allow temporary brace. Is it ok if that afraid is the responsibility of the brace. Get the brace takes some patience, so take some time.Download
