Thursday, May 26, 2011
Workshop manual Volvo Penta MD11C D MD17C
Methods of work described in the manual services apply to the work being carried out in the workshop. The engine was removed from the boat and is installed in the fixture of the engine. Tightening torques Protractor (angle). Do not re-use nuts which were removed during dismantling as they reduced service when again-use new nuts when mounting or reinstall.
Ingredient Guide: Stop device, bolt air injection pump, the delivery pipe nut Lock bolts, the crankshaft Centre bearing. . Aligning the pressure valve oil pressure sender. PISTONS AND CONNECTING RODS. Remove the control on the crankcase (head slot 6 mm). MD17: Remove sump and strainer. Remove carrier on the crankshaft.
