Wednesday, June 22, 2011
00-Up Toyota Celica 19,400 Sport sprężynami tops (Street)
Use the wrench 14 mm and 6 mm Allen wrench loosen and remove hardware holding sway bar end links to the front of the chassis dopompowanie those operations. Maintain hardware for later trial.
Loosen and remove the screws holding the brake lines to insert the rozpórke, you should use a 13 mm and 10 mm socket or wrench. Maintain hardware for later trial.
Use 21 mm and 22 mm socket or wrench loosen and remove the two screws, slide the rozpórke spindle bearing base. Loosen and remove the nuts, retaining the top slot rozpórke, use 12 mm socket or wrench. Push the rozpórke now is free and you can drop out of the vehicle. Be careful to avoid dropping push rozpórke, because it will damage the slot rozpórke or vehicle.
Place one of the Struts to spring compressor and coil spring until the collapse of the upper plate insert rozpórke is no longer energized. Remove the plastic cover of dust in the upper section of the Insert rozpórke. Using Socket 19 mm and 6 mm Allen wrench to remove the top nut foundations push rozpórke. The behavior of hardware to reinstall later.
Delete insert rozpórke the top ground plate, upper spring seat, rubber dust shield/Isolator spring and bump stop stock from the end of the slide rozpórke. This item should be left completely vulnerable to spring. Compression spring slowly release and remove the primary spring.
Move the new bump stops, push the end of the end of the narrow, rozpórke towards the bottom. Should rest just below the "shelf" at the end of the slide rozpórke. Position the new spring Hotchkis on push rozpórke. Be sure to align the urethral or tail, of Perch in the lower spring seat and the detachment serving.
Follow the arrows on the seat of the upper stamped in spring before reassembly. The arrow is highlighted in the picture below.
Replace the rubber dust separators spring/spring cover. The upper Spring seat placed at the top of the coil and align the Assembly of the coil. Sealed to the seat of the upper spring arrows select between two flanges in the lower slot rozpórke.
