Wednesday, June 22, 2011
E7355 real estate ' 03 Toyota Avensis (T25)
1. remove the bumper into the tray with the left side, remove the chassis stand eye and discard, reduce emissions, remove the screw rearmost, securing the heat shield. Remove clips along the lower edge of the bumper and remove the coverings boot.
2. Bolt (B) to the chassies using bolt R/s. A to b with a and b and K, using the drill up to machining screws to open the upper openings to j. inserting F.
3. Remove 4 rubber bungs each page from the bottom of the wings. Screw plate (e) to them using the C, n and assembled as shown using P, j. and g. fully tighten.
4. Secure the exhaust cieplochronnej using q by the other hole in b. reconnect combustion, etc. NB. There is a hole in the back of/s B.
5. Locking D using the l and m and finally using h fit balls and tubes set (not supplied with this kit).
This wsporczy must be used with the ball was consistent in terms of a 50-1 with a suitable values of D and s.
We hope you find it wsporczy easy to fit and that it will tow you satisfied with the force of the wsporczy Anker behind you.
