Wednesday, June 22, 2011
2002 Volvo XC70 P5-rear wheel hub by replacing the 2.4 l Service
Remove the rear wheel screw shaft/wheel hub. Remove the rear wheel hub
Delete a Vernier caliper brake mounting screws. Disconnect a Vernier caliper hardware wire locating pin for the disc brake disc ABS-ABS sensor cable holder. Disconnect the sensor using a piece of wire.
Delete insert the spring with a lower control arm rozpórke Note: insert the spring is compressed slightly rozpórke. Delete, being a regulator from the limbs of the upper border of the control key usage as Torx counterhold so that rubber boot is not damaged. Remove the Rod has a tie to the shaft. Angle Rod tie up so that the internal control arm Assembly is exposed the screw holding the lower control arm to the frame mounting. Bending control arm down. Remove the screws from the rear wheel hub hub near the rear wheel spindles and driveshaft. Note: Clean splines on the shaft before installing a new wheel hub. Lubricate splines with oil.
