Monday, June 13, 2011
Acura/Honda NSX BOOSTZILA Super charging system installation
The preparation steps for the installation of the fuel system
And: the adjustment of the two full backs with a leading position in the perpendicular position.
(B): disconnect the negative battery cable.
(C): remove the rear inner panels, starting with a long piece across the width of the car under the rear glass. Also delete the two flat panel located under the seats. Also delete the two corner pieces. And, finally, remove the Assembly Speaker and cover the rear Center. (The long bar across the width of the 3 push lock barbed style ensure pin w/one at both ends and in the Centre) (2 Flat panels have 4 push lock barbed securing pins, w/each tip is located a few inches from each corner of the Panel) (Corner of the section is held in place with 3 Philips screws, then removing the flat panels)
(D): delete the engine cover.
(E): remove the parentheses from the resistance of the motor area.
(F): delete the stock air box Assembly.
(G): remove the fuel rail includes the engine cover, name plates and metal intake manifold.
(H): carefully raise the car using the automotive lift. If the automotive lift available by using a floor jack. If using a floor jack increase to the highest possible to safely get 4 jack the vehicle is below the body of a unit in the respective factory recommended position. The car must be high enough to remove the fuel tank.
(I): remove the rear wheels during this time.
(J): relieve the pressure of the fuel in the fuel tanks of the release of the tank.
