Monday, June 13, 2011
Installation manual for one frame front bumper Audi A6 4B HF 7551 C5
1. Remove the original bumper:
Remove all screws that hold the bumper. Also, remove the screws that hold the alloys and remove the bumper with stripe of the alloy. Delete the alloy from the bumper and install it into the new Hofele-Design of the bumper.
2. the location of the Hofele-Design of the front bumper of the car:
Place the new fender on the car, but are not yet latch on.
3. preparation of the bonnet:
Remove the front Grill and rubber strap for him. Install in the front Grill (HF 7052-S4/RS4) in the extension piece.
4. the location of the extension:
Place the tube on the bonnet/hood, and repaired with adhesive tape. Align the front Grill, so that neither the slit between the bumper and grill.
5. Screwing the bumper:
After the correct alignment of the bumper and the front Grill can screw the bumper. Therefore, the drilling two holes with a diameter of 10 mm on the bumper and a diameter of 8 mm to the alloy. After you remove the M8 thread into the holes. Using the supplied screws + washers Screw on the bumper.
6. the Gluing tube and bonnet/hood:
Select the correct position of the tube with adhesive tape. Sand on the surface, and later to clean it. Then apply a special glue (part of delivery) to the currently defined. The extension piece is placed on the bonnet/hood and fix it with adhesive tape, until the glue is dry (at least 24 hours).
