Saturday, June 4, 2011
1994-1997 Honda Accord Dyno-Prove Intake System Installation
1994-1997 Honda Accord Dyno-Prove Intake System Installation. Disconnect the negative battery teriminal before starting this Honda Accord intake system installation. Remove the air intake box cover and intake air intake duct leading to the throttle body. Remove the PCV pipe as seen in figure 4 and replace the water bypass valve with the 15”- 6mm hose provided in the kit. The coolant line port is located on the intake manifold housing . See diagram’s A or B The location of the coolant line port hose may vary depending on the year of your car. ( Do not attempt to remove any lines until your engine is cool to the touch.). All Ex-models 94-97- Remove all of the components as seen in diagram C- #8. Since the cold air intake is not being used in this application the air resonator box can remain in the stock location. Once the components have been removed from the metal pipe leading to the EGR valve, you may cap-off or plug as indicated in figure 6 and diagram C. Use the 5mm vacuum cap to seal the line. Screw the vibra-mount into the fender wall as seen in figure 3 and use the m6 nut and washer to attach it.
DOWNLOAD PDF 1994-1997 Honda Accord Dyno-Prove Intake System Installation.PDF
