Wednesday, June 22, 2011
Toyota Avensis EGO TS installation,
Installation of user TS EGO in your car requires specifically nuclear knowledge and skills. We recommend that you install a qualified professional workshops. Before installing in your car please be sure that your mobile phone is fully compatible with the EGO of the TS. If you are unsure, refer to the retailer or professional workshop. Our team of service will also help you with any information they may require.
Mounting components
DAMAGE TO ESSENTIAL PARTS OF VEHICLES! The basic vehicle components or wiring may be corrupted when drilling mounting holes or screwing in self threading screws. Make sure that there is always enough space associated with holes drilled holes for the screws and
Electronics box Assembly
Define mount points, making sure that there is at least 70 mm in the space for plugs and socket connectors. Mark items for the bolts.
Electronics box Assembly
Mounting box electronics, using four bolts self-threading and suitable pads. We recommend that the size of the "ST 2, 9 × 25 DIN 7981" self threading screws. These are ideal for determining the field of electronics. Pre-Drill hole drill 2 mm.
Mounting the microphone
Define the location of the Assembly
Self-adhesive microphone holder has the tape from the rear. The space for mounting shall have the same form and space, as the tape self-adhesive microphone holder. The place chosen must allow the microphone cable to reach the field of electronics! Locate the microphone head in the direction of the speech.
Cleaning and degreasing mounting location
The space for mounting shall be clean and free from grease and dirt/dust. Clean up of the proposed area of the cleaning product, such as spirits. Only use cleaning products that do not damage the plastics or varnished wood trim and sami are free from oil or grease. Inadequate cleansers are for example: lighter fluid, Turpentine, acetone, trichloroethylene and similar products.
Attach the microphone holder
Would peel off the protective backing from the adhesive tape. Hold the microphone holder, just a few millimetres above the location of the requested Assembly. Please check again, positioning. Changing the position after mounting is no longer possible. Placeholder for the microphone to the space for mounting and correction by persuading short and light.
