Wednesday, June 22, 2011
Toyota Celica 1.8 l part number 57-0502 installation instructions
Toyota Corolla 1.6 l 16v 116bhp (4A-FE engine) 1992-1997
Disconnect the battery negative terminal of the battery. Carefully Disconnect and remove the air temperature sensor, with its lid box air. (Fig. 1) Unclip and remove the hose from intake to the throttle housing. Unclip and remove the air box Assembly of lid from the vehicle. Unscrew the hexagon and the removal of the base air field from the vehicle. Secure wires using one of the links of plastic material, delivered. Adjust the shaft hose throttle housing and safer use of the hose clamp # 40 delivered. Fit tube plastic hose and intake in the gelding safer use of the hose clamp # 48 shipped.Adjust the filter Adapter rubber onto the plastic intake. Fit the temperature sensor in a small hole in the filter. Matching filter air filter Adaptor rubber and safe use of belt-snake # 72 delivered. Reconnect the electrical connector for sensor provisional air. Cautiously expand the cold air hose, flexible, and pierce the drill a hole in one/of the ends of a plastic.
ONLY THE CELICA
Feed bags at the end of the cold air to vent hose in the lower area of the tray and a safe position, as shown by using one of the plastic ties, delivered. Place the end of the hose, the cold air in the direction of the air filter to complete approximately 4 "/10 cm away from the hotel and safe in position using one of the links of plastic material, delivered. Reconnect the battery negative terminal. Carry out the final height/alignment check niewmontowanych set, the installation has been completed.
