Wednesday, June 22, 2011
1992 Toyota Corolla valve cover gasket, replace
In 1992 Toyota Corolla., sandwiched between the head of the engine and the valve cover, valve cover gasket we can find. Valve cover is located, because it is outside the open side of the engine. It is about 2 feet long and has a small breather valve at the top of it. When the valve cover gasket goes bad, oil leaking from the valve cover and the head of the engine. This makes the engine smoke and could result in engine failure, if enough oil leaks.1. Remove the screws that secure the valve cover on the engine head with slots and located.
2. place a small screwdriver flat head screws between the valve cover and the head of the engine and that cover off of the head.
3. Scrape off the rubber gasket head engine using a metal scraper. The same is at the bottom of the valve cover. Clean both surfaces, clean diesel, and the old gasket material using a towel shop.
4. AUDIO VIDEO bead seal mating surface sealer head on the engine and the valve cover. Wait 20 minutes before you go. This allows the company to the sealer.
